leviton motion sensor light switch programming

Programming Your Leviton Motion Sensor Light Switch: A Step-by-Step Guide

Are you struggling to get your new Leviton motion sensor light switch up and running? If so, don't worry - programming it is a relatively straightforward process. In this article, we'll walk you through the steps to put your Leviton switch into pairing mode and ensure that everything is working correctly.

Step 1: Power Off Your Switch

Before you start, make sure that your Leviton switch is powered off at your circuit breaker. This will prevent any accidental power surges or electrical shocks while you're working on it.

Step 2: Locate the Reset Button

Next, locate the reset button on the bottom of your Leviton switch. It's usually red or black and has a small indentation in it. Use a flathead screwdriver to press down on the button until it clicks twice.

Step 3: Remove the Wall Plate

Once you've pressed the reset button, remove the wall plate that covers the main switch by unscrewing it from the wall. This will give you access to the switch's internal components.

Step 4: Press Down on the Reset Button Again

Using your flathead screwdriver, press down on the reset button again until it clicks twice. This indicates that the switch has been successfully reset.

Step 5: Re-secure the Wall Plate

Now that your switch is reset, re-secure the wall plate to the wall using screws if necessary.

Step 6: Turn On the Power and Test Your Switch

Finally, turn on the power at your circuit breaker and test out your newly reset Leviton light switch. If everything is working correctly, you should be able to use it like normal again.

Putting Your Leviton Switch in Pairing Mode

If you're having trouble with your Leviton light switch, you may need to put it into pairing mode. This can be done by following these steps:

Step 1: Power Off Your Switch

Make sure that your Leviton switch is powered off at your circuit breaker.

Step 2: Locate the Pairing Button

Locate the pairing button on the side of your Leviton switch. Press and hold it until you see a blue light blinking, indicating that the switch is in pairing mode.

Step 3: Open Your Wi-Fi Settings

Open your phone or tablet's Wi-Fi settings and locate your Leviton switch in the list of available networks.

Step 4: Enter the Default Password

Select your Leviton switch and enter the default password, which is usually 'Leviton123' unless you've changed it previously.

Resetting a Leviton motion sensor light switch can seem intimidating, but with these simple steps, you should be able to get it up and running in no time. Remember to always turn off the power at your circuit breaker before attempting any repairs, and never hesitate to contact an electrician if you're unsure about anything.

By following this guide, you'll be able to program your Leviton motion sensor light switch with ease and enjoy the benefits of a fully functioning smart home system.

Leviton motion sensor light switch programming